Light Curtains Pick to Light

The Light Curtains Pick to Light allow for error prevention during partial picking processes in shelves and storage locations. An integrated green and red light job display shows the user when part picking processes were carried out correctly or incorrectly. The Pick to Light Curtains function on the basis of the Retro-Reflex principle. Both the transmitter and receiver are integrated in the same housing and require a reflector for their function. The reflector is pre-installed on the rear of the housing and reflects the neighboring Light Curtain.

Applicationss

• Shelf control at mounting stations/lines
• Shelf control at commissioning stations

Pick to Light Principle

Via the Input, the green job display is activated and signalizes that a part has to be picked from the shelf behind the Light Curtain. The correct pick is confirmed over the job display. In case of a wrong pick from another shelf without signal, a red job display will show.

Luminous cap

The luminous end cap for the job display has good 360° visibility.

Adjustments

The configuration of functions is done with the push of a button via the Teach key. The Output can be switched over from NO and NC. The job display can be changed from blink mode to shine mode.

Light Curtains with red Light

Thanks to the visible light spots, the Light Curtains with this type of light are very easy to adjust and facilitate the setup.